E702289_SH7290 Datasheet, PDF (241/252 Pages) Renesas Technology Corp – SH7290 E10A Emulator

2. Displaying the measured result
The measured result is displayed in the [Performance Analysis] window or the
PERFORMANCE_ANALYSIS command with 32 bits.
Figure 6.15 [Performance Analysis] Window
Note: If a performance counter overflows as a result of measurement, “********” will be
displayed.
3. Initializing the measured result
To initialize the measured result, select [Initialize] from the popup menu in the [Performance
Analysis] window or specify INIT with the PERFORMANCE_ANALYSIS command.
6.5.11 Notes on U Standby State
Controlling Vcc (main) in the U standby state clears settings for peripheral modules in the
SH7290 which the emulator uses for debugging. Thus the appropriate function must be selected in
the [Recovery Information] page of the [Configuration] dialog box so that debugging can be
continued after returning to the U standby state.
Note: When using the U standby state, be sure to connect the /CA pin to the emulator. For
details, refer to section 6.3, User System Interface Circuit.
Table 6.14 lists the items to be selected in the [Recovery Information] page of the [Configuration]
dialog box.
217