|
MC9S12XD256CAG Datasheet, PDF (800/1348 Pages) Freescale Semiconductor, Inc – MC9S12XDP512 Data Sheet | |||
|
◁ |
Chapter 21 External Bus Interface (S12XEBIV2)
21.5.1 Normal Expanded Mode
This mode allows interfacing to external memories or peripherals which are available in the commercial
market. In these applications the normal bus operation requires a minimum of 1 cycle stretch for each
external access.
21.5.1.1 Example 1a: External Wait Feature Disabled
The first example of bus timing of an external read and write access with the external wait feature disabled
is shown in
⢠Figure âExample 1a: Normal Expanded Mode â Read Followed by Writeâ
The associated supply voltage dependent timing are numbers given in
⢠Table âExample 1a: Normal Expanded Mode Timing VDD5 = 5.0 V (EWAITE = 0)â
⢠Table âExample 1a: Normal Expanded Mode Timing VDD5 = 3.0 V (EWAITE = 0)â
Systems designed this way rely on the internal programmable access stretching. These systems have
predictable external memory access times. The additional stretch time can be programmed up to 8 cycles
to provide longer access times.
21.5.1.2 Example 1b: External Wait Feature Enabled
The external wait operation is shown in this example. It can be used to exceed the amount of stretch cycles
over the programmed number in EXSTR[2:0]. The feature must be enabled by writing EWAITE = 1.
If the EWAIT signal is not asserted, the number of stretch cycles is forced to a minimum of 2 cycles. If
EWAIT is asserted within the predefined time window during the access it will be strobed active and
another stretch cycle is added. If strobed inactive, the next cycle will be the last cycle before the access is
finished. EWAIT can be held asserted as long as desired to stretch the access.
An access with 1 cycle stretch by EWAIT assertion is shown in
⢠Figure âExample 1b: Normal Expanded Mode â Stretched Read Accessâ
⢠Figure âExample 1b: Normal Expanded Mode â Stretched Write Accessâ
The associated timing numbers for both operations are given in
⢠Table âExample 1b: Normal Expanded Mode Timing VDD5 = 5.0 V (EWAITE = 1)â
⢠Table âExample 1b: Normal Expanded Mode Timing VDD5 = 3.0 V (EWAITE = 1)â
It is recommended to use the free-running clock (ECLK) at the fastest rate (bus clock rate) to synchronize
the EWAIT input signal.
MC9S12XDP512 Data Sheet, Rev. 2.21
802
Freescale Semiconductor
|
▷ |