|
MC9S12XD256CAG Datasheet, PDF (1029/1348 Pages) Freescale Semiconductor, Inc – MC9S12XDP512 Data Sheet | |||
|
◁ |
Number
of Modules
5
4
3
2
1
Table 24-61. Module Implementations on Derivatives
CAN0
yes
yes
yes
yes
yes
MSCAN Modules
CAN1
yes
yes
yes
â
â
CAN2
yes
yes
â
â
â
CAN3
yes
â
â
â
â
CAN4
yes
yes
yes
yes
â
SPI Modules
SPI0
â
â
yes
yes
yes
SPI1
â
â
yes
yes
â
SPI2
â
â
yes
â
â
24.0.7 Ports
24.0.7.1 BKGD Pin
The BKGD pin is associated with the S12X_BDM and S12X_EBI modules. During reset, the
BKGD pin is used as MODC input.
24.0.7.2 Port A and B
Port A pins PA[7:0] and Port B pins PB[7:0] can be used for either general-purpose I/O.
24.0.7.3 Port E
Port E pins PE[7:2] can be used for either general-purpose I/O or with the alternative functions.
Port E pin PE[7] an be used for either general-purpose I/O or as the free-running clock ECLKX2
output running at the core clock rate. The clock output is always enabled in emulation modes.
Port E pin PE[4] an be used for either general-purpose I/O or as the free-running clock ECLK
output running at the bus clock rate or at the programmed divided clock rate. The clock output is
always enabled in emulation modes.
Port E pin PE[1] can be used for either general-purpose input or as the level- or falling edge-
sensitive IRQ interrupt input. IRQ will be enabled by setting the IRQEN configuration bit
(Section 24.0.5.10, âIRQ Control Register (IRQCR)â) and clearing the I-bit in the CPUâs condition
code register. It is inhibited at reset so this pin is initially configured as a simple input with a pull-
up.
Port E pin PE[0] can be used for either general-purpose input or as the level-sensitive XIRQ
interrupt input. XIRQ can be enabled by clearing the X-bit in the CPUâs condition code register. It
is inhibited at reset so this pin is initially configured as a high-impedance input with a pull-up.
24.0.7.4 Port K
Port K pins PK[7:0] can be used for either general-purpose I/O.
|
▷ |