MC908MR16CFUE Datasheet, PDF (44/282 Pages) Freescale Semiconductor, Inc – On-chip programming firmware for use with host personal computer, Clock generator module (CGM)

Memory
START ADDRESS OF FLASH
BLOCK PROTECT ¹
16-BIT MEMORY ADDRESS
FLBPR VALUE
0000000
Figure 2-6. FLASH Block Protect Start Address
Refer to Table 2-2 for examples of the protect start address.
Table 2-2. Examples of Protect Start Address
BPR[7:0]
Start of Address of Protect Range
$00
The entire FLASH memory is protected.
$01 (0000 0001)
$8080 (1000 0000 1000 0000)
$02 (0000 0010)
$8100 (1000 0001 0000 0000)
and so on...
$FE (1111 1110)
$FF00 (1111 1111 0000 0000)
$FF
The entire FLASH memory is not protected.
Note: The end address of the protected range is always $FFFF.
2.8.7 Wait Mode
Putting the MCU into wait mode while the FLASH is in read mode does not affect the operation of the
FLASH memory directly, but there will not be any memory activity since the CPU is inactive.
The WAIT instruction should not be executed while performing a program or erase operation on the
FLASH. Otherwise, the operation will discontinue, and the FLASH will be on standby mode.
2.8.8 Stop Mode
Putting the MCU into stop mode while the FLASH is in read mode does not affect the operation of the
FLASH memory directly, but there will not be any memory activity since the CPU is inactive.
The STOP instruction should not be executed while performing a program or erase operation on the
FLASH, otherwise the operation will discontinue, and the FLASH will be on standby mode
NOTE
Standby mode is the power-saving mode of the FLASH module in which all
internal control signals to the FLASH are inactive and the current
consumption of the FLASH is at a minimum.
MC68HC908MR32 • MC68HC908MR16 Data Sheet, Rev. 6.1
44
Freescale Semiconductor