MC908MR16CFUE Datasheet, PDF (115/282 Pages) Freescale Semiconductor, Inc – On-chip programming firmware for use with host personal computer, Clock generator module (CGM)

Chapter 12
Pulse-Width Modulator for Motor Control (PWMMC)
12.1 Introduction
This section describes the pulse-width modulator for motor control (PWMMC, version A). The PWM
module can generate three complementary PWM pairs or six independent PWM signals. These
PWM signals can be center-aligned or edge-aligned. A block diagram of the PWM module is shown in
Figure 12-2.
A12-bit timer PWM counter is common to all six channels. PWM resolution is one clock period for
edge-aligned operation and two clock periods for center-aligned operation. The clock period is dependent
on the internal operating frequency (f_OP) and a programmable prescaler. The highest resolution for
edge-aligned operation is 125 ns (f_OP = 8 MHz). The highest resolution for center-aligned operation is
250 ns (f_OP = 8 MHz).
When generating complementary PWM signals, the module features automatic dead-time insertion to the
PWM output pairs and transparent toggling of PWM data based upon sensed motor phase current
polarity.
A summary of the PWM registers is shown in Figure 12-3.
12.2 Features
Features of the PWMMC include:
• Three complementary PWM pairs or six independent PWM signals
• Edge-aligned PWM signals or center-aligned PWM signals
• PWM signal polarity control
• 20-mA current sink capability on PWM pins
• Manual PWM output control through software
• Programmable fault protection
• Complementary mode featuring:
– Dead-time insertion
– Separate top/bottom pulse width correction via current sensing or programmable software bits
MC68HC908MR32 • MC68HC908MR16 Data Sheet, Rev. 6.1
Freescale Semiconductor
115