MC908MR16CFUE Datasheet, PDF (176/282 Pages) Freescale Semiconductor, Inc – On-chip programming firmware for use with host personal computer, Clock generator module (CGM)

Serial Communications Interface Module (SCI)
In applications that are subject to software latency or in which it is important to know which byte is lost
due to an overrun, the flag-clearing routine can check the OR bit in a second read of SCS1 after
reading the data register.
NF — Receiver Noise Flag Bit
This clearable, read-only bit is set when the SCI detects noise on the PTF4/RxD pin. NF generates an
NF CPU interrupt request if the NEIE bit in SCC3 is also set. Clear the NF bit by reading SCS1 and
then reading the SCDR. Reset clears the NF bit.
1 = Noise detected
0 = No noise detected
FE — Receiver Framing Error Bit
This clearable, read-only bit is set when a 0 is accepted as the stop bit. FE generates an SCI error CPU
interrupt request if the FEIE bit in SCC3 also is set. Clear the FE bit by reading SCS1 with FE set and
then reading the SCDR. Reset clears the FE bit.
1 = Framing error detected
0 = No framing error detected
PE — Receiver Parity Error Bit
This clearable, read-only bit is set when the SCI detects a parity error in incoming data. PE generates
a PE CPU interrupt request if the PEIE bit in SCC3 is also set. Clear the PE bit by reading SCS1 with
PE set and then reading the SCDR. Reset clears the PE bit.
1 = Parity error detected
0 = No parity error detected
13.7.5 SCI Status Register 2
SCI status register 2 (SCS2) contains flags to signal these conditions:
• Break character detected
• Incoming data
Address: $003C
Bit 7
6
5
4
3
2
1
Bit 0
Read: 0
0
0
0
0
0
BKF
RPF
Write: R
R
R
R
R
R
R
R
Reset: 0
0
0
0
0
0
0
0
R = Reserved
Figure 13-13. SCI Status Register 2 (SCS2)
BKF — Break Flag
This clearable, read-only bit is set when the SCI detects a break character on the PTF4/RxD pin. In
SCS1, the FE and SCRF bits are also set. In 9-bit character transmissions, the R8 bit in SCC3 is
cleared. BKF does not generate a CPU interrupt request. Clear BKF by reading SCS2 with BKF set
and then reading the SCDR. Once cleared, BKF can become set again only after logic 1s again appear
on the PTF4/RxD pin followed by another break character. Reset clears the BKF bit.
1 = Break character detected
0 = No break character detected
MC68HC908MR32 • MC68HC908MR16 Data Sheet, Rev. 6.1
176
Freescale Semiconductor