MC908MR16CFUE Datasheet, PDF (249/282 Pages) Freescale Semiconductor, Inc – On-chip programming firmware for use with host personal computer, Clock generator module (CGM)

I/O Registers
MSxB:MSxA
X0
X1
00
00
00
01
01
01
01
1X
1X
1X
Table 17-2. Mode, Edge, and Level Selection
ELSxB:ELSxA
00
00
01
10
11
00
01
10
11
01
10
11
Mode
Output preset
Input capture
Output compare
or PWM
Buffered output
compare
or buffered
PWM
Configuration
Pin under port control; initialize timer output level high
Pin under port control; initialize timer output level low
Capture on rising edge only
Capture on falling edge only
Capture on rising or falling edge
Softare compare only
Toggle output on compare
Clear output on compare
Set output on compare
Toggle output on compare
Clear output on compare
Set output on compare
NOTE
When TOVx is set, a TIMB counter overflow takes precedence over a
channel x output compare if both occur at the same time.
CHxMAX — Channel x Maximum Duty Cycle Bit
When the TOVx is 1 and clear output on compare is selected, setting the CHxMAX bit forces the duty
cycle of buffered and unbuffered PWM signals to 100 percent. As Figure 17-9 shows, CHxMAX bit
takes effect in the cycle after it is set or cleared. The output stays at 100 percent duty cycle level until
the cycle after CHxMAX is cleared.
OVERFLOW
OVERFLOW
OVERFLOW
OVERFLOW
OVERFLOW
PERIOD
PTEx/TCHx
CHxMAX
TOVx
OUTPUT
COMPARE
OUTPUT
COMPARE
OUTPUT
COMPARE
OUTPUT
COMPARE
Figure 17-9. CHxMAX Latency
MC68HC908MR32 • MC68HC908MR16 Data Sheet, Rev. 6.1
Freescale Semiconductor
249