AK4671_10 Datasheet, PDF (115/166 Pages) Asahi Kasei Microsystems – Stereo CODEC with MIC/RCV/HP-AMP

[AK4671]
(2) I²C-bus Control Mode (I2C pin = “H”)
The AK4671 supports the fast-mode I²C-bus (max: 400kHz). Pull-up resistors at SDA and SCL pins should be connected
to (DVDD+0.3)V or less voltage.
(2)-1. WRITE Operations
Figure 98 shows the data transfer sequence for the I²C-bus mode. All commands are preceded by a START condition. A
HIGH to LOW transition on the SDA line while SCL is HIGH indicates a START condition (Figure 105). After the
START condition, a slave address is sent. This address is 7 bits long followed by the eighth bit that is a data direction bit
(R/W). The most significant six bits of the slave address are fixed as “001001”. The next bit is CAD0 (device address bit).
This bit identifies the specific device on the bus. The hard-wired input pin (CAD0 pin) sets these device address bits
(Figure 99). If the slave address matches that of the AK4671, the AK4671 generates an acknowledge and the operation is
executed. The master must generate the acknowledge-related clock pulse and release the SDA line (HIGH) during the
acknowledge clock pulse (Figure 106). A R/W bit value of “1” indicates that the read operation is to be executed. A “0”
indicates that the write operation is to be executed.
The second byte consists of the control register address of the AK4671. The format is MSB first, and the most significant
1-bit is fixed to “0” (Figure 100). The data after the second byte contains control data. The format is MSB first, 8bits
(Figure 101). The AK4671 generates an acknowledge after each byte is received. A data transfer is always terminated by
a STOP condition generated by the master. A LOW to HIGH transition on the SDA line while SCL is HIGH defines a
STOP condition (Figure 105).
The AK4671 can perform more than one byte write operation per sequence. After receipt of the third byte the AK4671
generates an acknowledge and awaits the next data. The master can transmit more than one byte instead of terminating the
write cycle after the first data byte is transferred. After receiving each data packet the internal 6-bit address counter is
incremented by one, and the next data is automatically taken into the next address. If the address exceeds 5AH prior to
generating a stop condition, the address counter will “roll over” to 00H and the previous data will be overwritten.
The data on the SDA line must remain stable during the HIGH period of the clock. The HIGH or LOW state of the data
line can only change when the clock signal on the SCL line is LOW (Figure 107) except for the START and STOP
conditions.
S
T
S
A
R/W="0"
T
R
O
T
P
SDA
Slave
S _Address
Sub
Address(n)
Data(n)
Data(n+1)
Data(n+x)
P
A
A
A
A
A
A
C
C
C
C
C
C
K
K
K
K
K
K
Figure 98. Data Transfer Sequence at the I²C-Bus Mode
0
0
1
0
0
1 CAD0 R/W
(The CAD0 should match with CAD0 pin.)
Figure 99. The First Byte
0
A6
A5
A4
A3
A2
A1
A0
Figure 100. The Second Byte
D7
D6
D5
D4
D3
D2
D1
D0
Figure 101. Byte Structure after the second byte
MS0666-E-02
- 115 -
2010/06