HD64F3664FPV Datasheet, PDF (206/446 Pages) Renesas Technology Corp – Old Company Name in Catalogs and Other Documents

Section 12 Timer W
Figure 12.8 shows an example of buffer operation when the GRA is set as an input-capture
register and GRC is set as the buffer register for GRA. TCNT operates as a free-running counter,
and FTIOA captures both rising and falling edge of the input signal. Due to the buffer operation,
the GRA value is transferred to GRC by input-capture A and the TCNT value is stored in GRA.
TCNT value
H'FFFF
H'DA91
H'5480
H'0245
H'0000
FTIOA
Time
GRA
GRC
H'0245
H'5480
H'0245
H'DA91
H'5480
Figure 12.8 Buffer Operation Example (Input Capture)
12.4.2 PWM Operation
In PWM mode, PWM waveforms are generated by using GRA as the period register and GRB,
GRC, and GRD as duty registers. PWM waveforms are output from the FTIOB, FTIOC, and
FTIOD pins. Up to three-phase PWM waveforms can be output. In PWM mode, a general register
functions as an output compare register automatically. The output level of each pin depends on the
corresponding timer output level set bit (TOB, TOC, and TOD) in TCRW. When TOB is 1, the
FTIOB output goes to 1 at compare match A and to 0 at compare match B. When TOB is 0, the
FTIOB output goes to 0 at compare match A and to 1 at compare match B. Thus the compare
match output level settings in TIOR0 and TIOR1 are ignored for the output pin set to PWM mode.
If the same value is set in the cycle register and the duty register, the output does not change when
a compare match occurs.
Rev. 6.00 Mar. 24, 2006 Page 176 of 412
REJ09B0142-0600