HD64F3664FPV Datasheet, PDF (127/446 Pages) Renesas Technology Corp – Old Company Name in Catalogs and Other Documents

Section 7 ROM
7.2 Register Descriptions
The flash memory has the following registers.
• Flash memory control register 1 (FLMCR1)
• Flash memory control register 2 (FLMCR2)
• Erase block register 1 (EBR1)
• Flash memory power control register (FLPWCR)
• Flash memory enable register (FENR)
7.2.1 Flash Memory Control Register 1 (FLMCR1)
FLMCR1 is a register that makes the flash memory change to program mode, program-verify
mode, erase mode, or erase-verify mode. For details on register setting, refer to section 7.4, Flash
Memory Programming/Erasing.
Bit
Initial
Bit
Name Value R/W
Description
7
—
0
—
Reserved
This bit is always read as 0.
6
SWE 0
R/W
Software Write Enable
When this bit is set to 1, flash memory
programming/erasing is enabled. When this bit is
cleared to 0, other FLMCR1 register bits and all EBR1
bits cannot be set.
5
ESU
0
R/W
Erase Setup
When this bit is set to 1, the flash memory changes to
the erase setup state. When it is cleared to 0, the
erase setup state is cancelled. Set this bit to 1 before
setting the E bit to 1 in FLMCR1.
4
PSU
0
R/W
Program Setup
When this bit is set to 1, the flash memory changes to
the program setup state. When it is cleared to 0, the
program setup state is cancelled. Set this bit to 1
before setting the P bit in FLMCR1.
Rev. 6.00 Mar. 24, 2006 Page 97 of 412
REJ09B0142-0600