MC9S08DZ128 Datasheet, PDF (428/458 Pages) Freescale Semiconductor, Inc – Microcontrollers

Appendix A Electrical Characteristics
Table A-7. Supply Current Characteristics (continued)
Num C
Parameter
Symbol
V_DD
(V)
Typ¹
Max²
Unit
8
P Adder to stop3 for oscillator enabled⁷
5
5
P ^{(EREFSTEN =1)}
S3I_DDOSC
3
5
8
μA
8
1 _{Typical are measured at 25°C. See Figure A-8 through Figure A-10 for typical curves across}
voltage/temperature.
2 _{Max values in this column apply for the full operating temperature range of the device unless otherwise}
noted.
3 _{All modules except ADC active, ICS configured for FBE, and does not include any dc loads on port pins}
4 _{All modules except ADC active, ICS configured for FEI, and does not include any dc loads on port pins}
5 _{Stop currents are tested in production for 25°C on all parts. Tests at other temperatures depend upon the}
part number suffix and maturity of the product. Freescale may eliminate a test insertion at a particular
temperature from the production test flow once sufficient data has been collected and approved.
6 _{Most customers are expected to find that auto-wakeup from stop2 or stop3 can be used instead of the}
higher current wait mode.
7 _{Values given under the following conditions: low range operation (RANGE = 0) with a 32.768kHz crystal}
and low power mode (HGO = 0).
18
16
PEI or FEI (mid range DCO)
FEI (low range DCO)
FBE
14
12
10
8
6
4
2
0
01 2 4
8
f_bus (MHz)
16
20
Figure A-5. Typical Run I_DD vs. Bus Frequency (V_DD = 5V)
MC9S08DZ128 Series Data Sheet, Rev. 1
428
Freescale Semiconductor