MC9S08DZ128 Datasheet, PDF (25/458 Pages) Freescale Semiconductor, Inc – Microcontrollers

Chapter 1 Device Overview
1.3 System Clock Distribution
Figure 1-2 shows a simplified clock connection diagram. Some modules in the MCU have selectable clock
inputs as shown. The clock inputs to the modules indicate the clock(s) that are used to drive the module
function.
The following are the clocks used in this MCU:
• BUSCLK — The frequency of the bus is always half of MCGOUT.
• LPO — Independent 1-kHz clock that can be selected as the source for the COP and RTC modules.
• MCGOUT — Primary output of the MCG and is twice the bus frequency.
• MCGLCLK — Development tools can select this clock source to speed up BDC communications
in systems where BUSCLK is configured to run at a very slow frequency.
• MCGERCLK — External reference clock can be selected as the RTC clock source. It can also be
used as the alternate clock for the ADC and MSCAN.
• MCGIRCLK — Internal reference clock can be selected as the RTC clock source.
• MCGFFCLK — Fixed frequency clock can be selected as clock source for the TPMx.
• TPM1CLK — External input clock source for TPM1.
• TPM2CLK — External input clock source for TPM2.
• TPM3CLK — External input clock source for TPM3.
TPM1CLK TPM2CLK TPM3CLK
1 kHZ
LPO
MCGERCLK
MCGIRCLK
RTC
COP TPM1 TPM2 TPM3 IIC1
IIC2 SCI1 SCI2 SPI1 SPI2
MCG
MCGFFCLK
÷2
FFCLK*
MCGOUT
MCGLCLK
÷2 ^BUSCLK
XOSC
CPU
BDC
ADC
MSCAN
EXTAL XTAL
* The fixed frequency clock (FFCLK) is internally
synchronized to the bus clock and must not exceed one half
of the bus clock frequency.
ADC has min and max
frequency requirements.
See the ADC chapter
and electricals appendix
for details.
Figure 1-2. System Clock Distribution Diagram
FLASH EEPROM
FLASH and EEPROM
have frequency
requirements for program
and erase operation. See
the electricals appendix
for details.
MC9S08DZ128 Series Data Sheet, Rev. 1
Freescale Semiconductor
25