XRT7250 Datasheet, PDF (369/463 Pages) Exar Corporation – DS3/E3 FRAMER IC

XRT7250
DS3/E3 FRAMER IC
REV. 1.1.1
áç
FIGURE 166. BEHAVIOR OF THE TERMINAL INTERFACE SIGNALS BETWEEN THE XRT7250 AND THE TERMINAL
EQUIPMENT (E3 MODE 5 OPERATION)
Terminal Equipment Signals
RxOutClk
E3_Nib_Clock_In
E3_Data_Out[3:0]
Tx_Start_of_Frame
E3_Overhead_Ind
Payload Nibble [1059]
Overhead Nibble [0]
XRT7250 Transmit Payload Data I/F Signals
RxOutClk
TxNibClk
TxNib[3:0]
TxFrameRef
Nibble [1059]
Overhead Nibble [0]
TxOH_Ind
Note: Terminal Equipment pulses
“TxFrameRef” in order to denote
the E3 Frame Boundary.
E3 Frame Number N
E3 Frame Number N + 1
TxOH_Ind pulses high for 4 Nibble periods
How to configure the XRT7250 into Mode 5
1. Set the NibIntf input pin "High".
2. Set the TimRefSel[1:0] bit-fields (within the
Framer Operating Mode Register) to "01" as illus-
trated below.
FRAMER OPERATING MODE REGISTER (ADDRESS = 0X00)
BIT 7
Local Loopback
BIT 6
DS3/E3*
R/W
R/W
0
0
BIT 5
Internal LOS
Enable
R/W
1
BIT 4
RESET
R/W
0
BIT 3
BIT2
Interrupt Enable Frame Format
Reset
R/W
R/W
1
0
BIT 1
BIT 0
TimRefSel[1:0]
R/W
R/W
0
1
3. Interface the XRT7250, to the Terminal Equip-
ment, as illustrated in Figure 165.
6.2.1.6 Mode 6 - The Nibble-Parallel/Local-
Timed/Frame-Master Interface Mode Behavior of
the XRT7250
If the XRT7250 has been configured to operate in this
mode, then the XRT7250 will function as follows:
A. Local Timing - Uses the TxInClk signal as the
Timing Reference
In this mode, the Transmit Section of the XRT7250
will use the TxInClk signal at its timing reference.
Further, the chip will internally divide the TxInClk
clock signal by a factor of 4 and will output this divid-
ed clock signal via the TxNibClk output pin. The
Transmit Terminal Equipment Input Interface block
(within the XRT7250) will use the rising edge of the
TxNibClk signal, to latch the data, residing on the Tx-
Nib[3:0] into its circuitry.
B. Nibble-Parallel Mode
350