LAN91C111_11 Datasheet, PDF (92/133 Pages) SMSC Corporation – 10/100 Non-PCI Ethernet Single Chip MAC + PHY

10/100 Non-PCI Ethernet Single Chip MAC + PHY
Datasheet
S/W DRIVER
MAC SIDE
4
When the end of packet is detected, the status word
is placed at the beginning of the receive packet in
memory. Byte count is placed at the second word. If
the CRC checks correctly the packet number is
written into the RX FIFO. The RX FIFO, being not
empty, causes RCV INT (interrupt) to be set. The
RCV_BAD bit of the Bank 1 Control Register controls
whether or not to generate interrupts when bad CRC
packets are received.
5 SERVICE INTERRUPT - Read the Interrupt Status
Register and determine if RCV INT is set. The next
receive packet is at receive area. (Its packet number
can be read from the FIFO Ports Register). The
software driver can process the packet by accessing
the RX area, and can move it out to system memory
if desired. When processing is complete the CPU
issues the REMOVE AND RELEASE FROM TOP OF
RX command to have the MMU free up the used
memory and packet number.
Revision 1.92 (06-27-11)
92
DATASHEET
SMSC LAN91C111 REV C