MC68HC908JB8 Datasheet, PDF (58/286 Pages) Motorola, Inc – MICROCONTROLLERS

FLASH Memory
4.7 FLASH Program Operation
Programming of the FLASH memory is done on a row basis. A row
consists of 64 consecutive bytes starting from addresses $XX00,
$XX40, $XX80 or $XXC0. The procedure for programming a row of the
FLASH memory is outlined below:
1. Set the PGM bit. This configures the memory for program
operation and enables the latching of address and data for
programming.
2. Write any data to any FLASH address within the address range of
the row to be programmed.
3. Wait for a time, t_nvs (5 µs).
4. Set the HVEN bit.
5. Wait for a time, t_pgs (10 µs).
6. Write data to the byte being programmed.
7. Wait for time, t_PROG (20 µs).
8. Repeat step 6 and 7 until all the bytes within the row are
programmed.
9. Clear the PGM bit.
10. Wait for time, t_nvh (5 µs).
11. Clear the HVEN bit.
12. After time, t_rcv (1 µs), the memory can be accessed in read mode
again.
This program sequence is repeated throughout the memory until all data
is programmed.
NOTE:
Programming and erasing of FLASH locations cannot be performed by
code being executed from the FLASH memory. While these operations
must be performed in the order shown, other unrelated operations may
occur between the steps. Do not exceed t_PROG maximum (see 18.13
Memory Characteristics).
Figure 4-3 shows a flowchart representation for programming the
FLASH memory.
Technical Data
58
MC68HC908JB8•MC68HC08JB8•MC68HC08JT8 — Rev. 2.3
FLASH Memory
Freescale Semiconductor