English
Language : 

MC9S12E256 Datasheet, PDF (566/602 Pages) Freescale Semiconductor, Inc – HCS12 Microcontrollers
Appendix A Electrical Characteristics
A.1.9 I/O Characteristics
This section describes the characteristics of all 3.3V/5V I/O pins. All parameters are not always applicable,
e.g., not all pins feature pull up/down resistances.
Table A-6. 5V I/O Characteristics
Conditions are shown in Table A-4 unless otherwise noted
Num C
Rating
Symbol
Min
Typ
Max
Unit
1
P Input High Voltage
T Input High Voltage
VIH
0.65*VDD5
—
—
V
VIH
—
—
VDD5 + 0.3
V
2
P Input Low Voltage
T Input Low Voltage
VIL
—
—
0.35*VDD5
V
VIL
VSS5 – 0.3
—
—
V
3
C Input Hysteresis
VHYS
—
250
4
P Input Leakage Current (pins in high ohmic input
mode)1
Iin
Vin = VDD5 or VSS5
–1.0
—
5
C Output High Voltage (pins in output mode)
Partial Drive IOH = –2mA
VOH
VDD5 – 0.8
—
—
mV
1.0
µA
—
V
6
P Output High Voltage (pins in output mode)
Full Drive IOH = –10mA
VOH
VDD5 – 0.8
—
—
V
7
C Output Low Voltage (pins in output mode)
Partial Drive IOL = +2mA
VOL
—
—
0.8
V
8
P Output Low Voltage (pins in output mode)
Full Drive IOL = +10mA
VOL
—
9
P Internal Pull Up Device Current, tested at VIL Max. IPUL
—
10
C Internal Pull Up Device Current, tested at VIH Min. IPUH
–10
11
P Internal Pull Down Device Current, tested at VIH
IPDH
—
Min.
—
0.8
V
—
–130
µA
—
—
µA
—
130
µA
12
C Internal Pull Down Device Current, tested at VIL
IPDL
10
—
—
µA
Max.
13
D Input Capacitance
Cin
—
6
—
pF
14
T Injection current2
Single Pin limit
IICS
–2.5
—
Total Device Limit. Sum of all injected currents
IICP
–25
—
mA
2.5
25
15
P Port AD Interrupt Input Pulse filtered3
tPIGN
—
—
3
µs
16
P Port AD Interrupt Input Pulse passed3
tPVAL
10
—
—
µs
1 Maximum leakage current occurs at maximum operating temperature. Current decreases by approximately one-half for each
8°C to 12°C in the temperature range from 50°C to 125°C.
2 Refer to Section A.1.4, “Current Injection” for more details
3 Parameter only applies in STOP or Pseudo STOP mode.
MC9S12E256 Data Sheet, Rev. 1.08
566
Freescale Semiconductor