MC68HC908LJ24 Datasheet, PDF (342/464 Pages) Motorola, Inc – Microcontrollers

Analog-to-Digital Converter (ADC)
16.8 I/O Registers
These I/O registers control and monitor operation of the ADC:
• ADC status and control register, (ADSCR)
• ADC data register (ADRH:ADRL)
• ADC clock control register (ADCLK)
16.8.1 ADC Status and Control Register
This section describes the function of the ADC status and control
register (ADSCR). Writing ADSCR aborts the current conversion and
initiates a new conversion.
Address: $003C
Read: COCO
Write:
Reset: 0
AIEN ADCO
0
0
= Unimplemented
ADCH4
1
ADCH3
1
ADCH2
1
ADCH1
1
ADCH0
1
Figure 16-4. ADC Status and Control Register (ADSCR)
COCO — Conversions Complete Bit
When the AIEN bit is a logic 0, the COCO is a read-only bit which is
set each time a conversion is completed. This bit is cleared whenever
the ADSCR is written, or whenever the ADC clock control register is
written, or whenever the ADC data register low, ADRL, is read.
If the AIEN bit is logic 1, the COCO bit always read as logic 0, CPU to
service the ADC interrupt will be generated at the end if an ADC
conversion. Reset clears the COCO bit.
1 = Conversion completed (AIEN = 0)
0 = Conversion not completed (AIEN = 0)/CPU interrupt (AIEN=1)
AIEN — ADC Interrupt Enable Bit
When this bit is set, an interrupt is generated at the end of an ADC
conversion. The interrupt signal is cleared when the data register,
ADR0, is read or the ADSCR is written. Reset clears the AIEN bit.
1 = ADC interrupt enabled
0 = ADC interrupt disabled
Data Sheet
342
Analog-to-Digital Converter (ADC)
MC68HC908LJ24/LK24 — Rev. 2.1
Freescale Semiconductor