MC68HC05B6_13 Datasheet, PDF (223/302 Pages) Freescale Semiconductor, Inc – Microcontrollers

F.2
External clock
When using an external clock the OSC1 and OSC2 pins should be driven in antiphase (see
Figure D-2). The t_OXOV or t_ILCH specifications (see Section F.9) do not apply when using an
external clock input. The equivalent specification of the external clock source should be used in
lieu of t_OXOV or t_ILCH.
F.3
RESET pin
When the oscillator is running in a stable condition, the MCU is reset when a logic zero is applied
to the RESET input for a minimum period of 3.0 machine cycles (t_CYC). For more information see
Section 9.1.3.
F.4
EPROM
The MC68HC705B16N memory map is given in Figure F-2. The device has a total of 15168 bytes
of EPROM (including 14 bytes for User vectors) and 256 bytes of EEPROM.
The EPROM array is supplied by the VPP6 pin in both read and program modes. Typically the
user’s software would be loaded into a programming board where V_PP6 is controlled by one of the
bootstrap loader routines. It would then be placed in an application where no programming occurs.
In this case the VPP6 pin should be hardwired to V_DD.
Warning: A minimum V_DD voltage must be applied to the VPP6 pin at all times, including
power-on. Failure to do so could result in permanent damage to the device. Unless
otherwise stated, EPROM programming is guaranteed at ambient (25°C) temperature
only.
F.4.1 EPROM read operation
The execution of a program in the EPROM address range or a load from the EPROM are both
read operations. The E6LAT bit in the EPROM/EEPROM control register should be cleared to ‘0’
which automatically resets the E6PGM bit. In this way the EPROM is read like a normal ROM.
Reading the EPROM with the E6LAT bit set will give data that does not correspond to the actual
memory content. As interrupt vectors are in EPROM, they will not be loaded when E6LAT is set.
Similarly, the bootstrap ROM routines cannot be executed when E6LAT is set. In read mode, the
VPP6 pin must be at the V_DD level. When entering the STOP mode, the EPROM is automatically
set to the read mode.
Note: An erased byte reads as $00.
14
MC68HC05B6
Rev. 4.1
MC68HC705B16N
Freescale
F-5