TLK100_11 Datasheet, PDF (47/88 Pages) Texas Instruments – Industrial Temp, Single Port 10/100 Mb/s Ethernet Physical Layer Transceiver

TLK100
www.ti.com
SLLS931B – AUGUST 2009 – REVISED DECEMBER 2009
8.1.5 Auto-Negotiation Advertisement Register (ANAR)
This register contains the advertised abilities of this device as they are transmitted to its link partner during
Auto- Negotiation.
Table 8-7. Auto Negotiation Advertisement Register (ANAR), address 0x0004
BIT BIT NAME
15 NP
14 RESERVED
13 RF
12 RESERVED
11 ASM_DIR
10 PAUSE
9 T4
8 TX_FD
7 TX
6 10_FD
5 10
4:0 Selector
DEFAULT
DESCRIPTION
0, RW
Next Page Indication:
0 = Next Page Transfer not desired.
1 = Next Page Transfer desired.
0, RO/P RESERVED by IEEE: Writes ignored, Read as 0.
0, RW
Remote Fault:
1 = Advertises that this device has detected a Remote Fault.
0 = No Remote Fault detected.
0, RW
RESERVED for Future IEEE use: Write as 0, Read as 0
0, RW
Asymmetric PAUSE Support for Full Duplex Links:
1 = Asymmetric PAUSE implemented.
0 = Asymmetric PAUSE not implemented.
0, RW
PAUSE Support for Full Duplex Links:
1 = MAC PAUSE implemented
0 = MAC PAUSE not implemented
0, RO/P 100BASE-T4 Support:
1 = 100BASE-T4 is supported by the local device.
0 = 100BASE-T4 not supported.
Jumper, RW 100BASE-TX Full Duplex Support:
1 = 100BASE-TX Full Duplex is supported by the local device.
0 = 100BASE-TX Full Duplex not supported.
Jumper, RW 100BASE-TX Support:
1 = 100BASE-TX is supported by the local device.
0 = 100BASE-TX not supported.
Jumper, RW 10BASE-T Full Duplex Support:
1 = 10BASE-T Full Duplex is supported by the local device.
0 = 10BASE-T Full Duplex not supported.
Jumper, RW 10BASE-T Support:
1 = 10BASE-T is supported by the local device.
0 = 10BASE-T not supported.
<00001>, RW Protocol Selection Bits:
These bits contain the binary encoded protocol selector supported by this port. <00001> indicates that
this device supports IEEE 802.3u.
Copyright © 2009, Texas Instruments Incorporated
Submit Documentation Feedback
Product Folder Link(s): TLK100
Register Block
47