TLK100_11 Datasheet, PDF (21/88 Pages) Texas Instruments – Industrial Temp, Single Port 10/100 Mb/s Ethernet Physical Layer Transceiver

TLK100
www.ti.com
4 Interfaces
SLLS931B – AUGUST 2009 – REVISED DECEMBER 2009
4.1 Media Independent Interface (MII)
The Media Independent Interface (MII) is a synchronous 4-bit wide nibble data interface that connects the
PHY to the MAC in 100B-TX and 10B-T modes. The MII is fully compliant with IEEE802.3-2002 clause 22.
The MII consists of the data signals MII_TXD[3:0] and MII_RXD[3:0], transmit and receive valid signals
MII_TX_EN and MII_RX_DV, error signal MII_RX_ERR and transmit/receive clocks MII_TX_CLK and
MII_RX_CLK. In addition, the interface consists of asynchronous line status signals MII_CRS and
MII_COL, indicating carrier sense and collision. Data on MII_TXD[3:0] and MII_RXD[3:0] are latched with
reference to the edges of MII_RX_CLK and MII_TX_CLK clocks respectively as defined in the MII timing
diagrams 22-14 and 22-15 of IEEE802.3-2002 clause 22. Both clocks are sourced by the PHY. In
100B-TX mode, the MII_RX_CLK and MII_TX_CLK source 25MHz clocks and in 10B-T, they source
2.5MHz clocks.
Figure 4-1 describes the MII signals connectivity.
TLK100
MII_TX_CLK
MII_TX_EN
MII_TXD [3:0]
MII_RX_CLK
MII_RX_DV
MII_RX_ERR
MII_RXD [3:0]
MII_CRS
MII_COL
TX_CLK
TX_EN
TXD [3:0]
RX_CLK
RX_DV
RX_ER
RXD [3:0]
CRS
COL
MAC
Figure 4-1. MII Signaling
The isolate register 0.10 defined in IEEE802.3-2002 used to electrically isolate the PHY from the MII (if
set, all transactions on the MII interface are ignored by the PHY).
Additionally, the MII interface includes the carrier sense signal MII_CRS, as well as a collision detect
signal MII_COL. The MII_CRS signal asserts to indicate the reception of data from the network or as a
function of transmit data in Half Duplex mode. The MII_COL signal asserts as an indication of a collision
which can occur during half-duplex operation when both transmit and receive operation occur
simultaneously.
Copyright © 2009, Texas Instruments Incorporated
Submit Documentation Feedback
Product Folder Link(s): TLK100
Interfaces
21