R0E417250MCU00 Datasheet, PDF (80/228 Pages) Renesas Technology Corp – E100 Emulator MCU Unit for H8SX/1700 Series

R0E417250MCU00 User’s Manual
5. Debugging Functions
5.1.2 Setting Up the Target MCU
(1) Selecting the target MCU
On the Device page of the Device setting dialog box, specify the target MCU to be emulated. For details, refer to the hardware
manual supplied with each product.
Figure 5.1 Device setting dialog box (Device page)
The target MCU you have set here cannot be changed after the emulator is connected. To change the target MCU, you need to
disconnect and then reconnect the emulator.
(2) Selecting an operation mode
Select an operating mode.
For details, refer to the hardware manual for the MCU in use.
(3) Automatic detection of operating mode
Select the checkbox if you want automatic detection of the operating mode after connection of the emulator has been
established. When any of the following states is detected, the emulator shows an error message and releases the connection.
- The user system is not connected.
- The user system is not supplied with power.
- The setting of the MD2 to MD0 pins of the user system corresponds to an operating mode that is not supported by the
emulator.
Even if the [Automatic Detection] checkbox is not selected and the user system is being supplied with power, the emulator
checks the states of the MD2 to MD0 pins against the operating mode selection made by the user. When they do not match or
the operating mode indicated by the MD2 to MD0 pins is not available, the emulator shows a message and makes the
connection for the operating mode selected by the user.
REJ10J1831-0200 Rev.2.00 Jun.1, 2009
Page 80 of 228