R0E417250MCU00 Datasheet, PDF (58/228 Pages) Renesas Technology Corp – E100 Emulator MCU Unit for H8SX/1700 Series

R0E417250MCU00 User’s Manual
3. Tutorial
3.17.2 Showing the Information Acquired in “Fill around TP” Tracing
In “fill around TP” tracing, the acquisition of trace information is stopped a specified number of cycles after a trace point is
encountered. This facility allows you to use trace information to keep track of program flow without having to break the user
program.
(1) If any break conditions are set, clear all of them.
(2) Choose “Fill around TP” as the trace mode in the Trace conditions dialog box. In the Delay (cycle) section, specify 4M.
(Up to 4-M cycles of trace information from where a trace point is encountered will be acquired.)
Figure 3.34 Trace conditions dialog box (Fill around TP)
REJ10J1831-0200 Rev.2.00 Jun.1, 2009
Page 58 of 228