R0E417250MCU00 Datasheet, PDF (20/228 Pages) Renesas Technology Corp – E100 Emulator MCU Unit for H8SX/1700 Series

R0E417250MCU00 User’s Manual
2. Setup
1.4 Specifications
Table 1.5 lists the specifications of the R0E417250MCU00.
Table 1.5 Specifications of the R0E417250MCU00
Applicable MCU
H8SX-family H8SX/1700-series MCUs
Applicable MCU mode
Single-chip mode, On-chip ROM enabled extended mode
Maximum ROM/RAM capacity
1. Internal flash ROM: 1 Mbytes
2. Internal RAM: 64 Kbytes
3. Internal EEPROM: 32 Kbytes
Maximum operating frequency
80 MHz
Power supply voltage
3.0 to 3.6V, 4.5 to 5.5V
Software break
4096 points
Hardware break
16 points (Execution address, bus detection, interrupt, external trigger signal)
Combination, pass count
- Cumulative AND/OR/simultaneous AND/state transition
- 255 pass counts
Detection of exceptional events
Violation of access protection/task stack access violation/OS dispatch/reading
from a non-initialized area
Real-time tracing
192 bits × 4 M cycles
(Address, data, status, CPU status, bus status, target status, task ID, timestamp, 32
external trigger inputs)
Trace modes
Fill until stop/fill until full/fill around TP/repeat fill until stop/repeat fill until full
Extraction/deletion of trace data
- Extracting or deleting data by specifying events or extracting the instruction that
accesses the specified data
- Extracting data before and after trace points
Real-time RAM monitor
- 16,384 bytes (512 bytes × 32 blocks)
- Data/last access
Time measurement
- Execution time between program start and stop
- Maximum/minimum/average execution time and number of passes through eight
specified sections
- Clock used to count times: Equal to the MCU clock or 10ns to 1.6 us
Coverage measurement
C0: 2 Mbytes (256 Kbytes × 8 blocks)
C1: 1 Mbyte (128 Kbytes × 8 blocks)
Emulation memory
4 Mbytes (1 Mbyte × 4 blocks)
Pseudo-generation of errors
Connection to user system
Detect if external oscillation has stopped and correct ROM/RAM ECC errors
100-pin 0.5-mm pitch LQFP
R0E0100TNPFK00
Emulator power supply
Supplied from included AC adapter (power supply voltage: 100 to 240 V, 50/60 Hz)
REJ10J1831-0200 Rev.2.00 Jun.1, 2009
Page 20 of 228