R0E417250MCU00 Datasheet, PDF (110/228 Pages) Renesas Technology Corp – E100 Emulator MCU Unit for H8SX/1700 Series

R0E417250MCU00 User’s Manual
5. Debugging Functions
2. If the number of events currently set allows room for another, the event you have added from the Editor window is added as
an OR condition. If there is no room, an error message is displayed.
CAUTION
If you are editing the contents of the Hardware Break dialog box, you cannot set a hardware breakpoint from the Event column
of the Editor window.
Figure 5.31 Hardware Break dialog box
[Adding a trace point]
1. Double-click or right click in the Event column of the Editor window then select Trace Point from the popup menu.
This sets fetching from the corresponding address as the condition for a trace point, i.e an instruction fetch condition.
Double-click on the instruction fetch event in the Event column of the Editor window to delete it.
CAUTION
Trace points cannot be set in the Event column of the Editor window in the following cases.
- The contents of the Trace conditions dialog box are being edited.
- The selected trace mode is Fill until stop or Fill until full.
REJ10J1831-0200 Rev.2.00 Jun.1, 2009
Page 110 of 228