R0E417250MCU00 Datasheet, PDF (22/228 Pages) Renesas Technology Corp – E100 Emulator MCU Unit for H8SX/1700 Series

R0E417250MCU00 User’s Manual
2. Setup
2. Setup
This chapter describes the preparation for using the MCU unit, the procedure for starting up the emulator and how to change
settings.
2.1 Flowchart of Starting Up the Emulator
The procedure for starting up the emulator is shown in Figures 2.1 and 2.2. For details, refer to each section hereafter. If the
emulator does not start up normally, refer to “6. Troubleshooting ” (page 211).
1
Check the package components.
▼
2
User registration
▼
3
Install the included software, etc.
▼
4
Connect the MCU unit to the E100 main
unit.
▼
5
Connect the host machine.
▼
6
Connect the emulator power supply.
▼
7
Turn on the power supply.
▼
8
Check the LEDs on the emulator.
▼
9
Try to use the emulator debugger according
to the tutorial.
▼
10
Create a project in the High-performance
Embedded Workshop.
▼
Start up the emulator debugger from the
11
High-performance Embedded Workshop.
▼
Set up the operating environment of the
12
emulator debugger.
▼
13
Self-checking
Refer to “1.1 Package Components” (page 16).
Refer to “User Registration” (page 14).
Install them from the included CD-ROM.
Refer to “2.3 Connecting the MCU Unit to and Disconnecting it
from the E100 Emulator Main Unit” (page 25)
Connect the USB interface connector of the emulator and the USB
port of the host machine.
Connect an emulator power supply to the power connector.
Turn ON the power to the emulator.
Check that the system status LEDs are lighting.
When using the emulator debugger for the first time, try to use the
emulator functions, referring to “3. Tutorial” (page 35).
If the emulator debugger does not start, follow steps 10 through 13
in this chart to perform self-checking.
Start up the High-performance Embedded Workshop and create a
project by following “4. Preparation for Debugging” (page 66).
Start up the High-performance Embedded Workshop to launch the
emulator debugger by following “4. Preparation for Debugging”
(page 66).
Make settings on the Device page in the Device setting dialog box
of the emulator debugger and select the “Start booting up on
successful completion of self-checking” checkbox by following
“4. Preparation for Debugging” (page 66).
Figure 2.1 Flowchart of starting up the emulator (for the first time)
REJ10J1831-0200 Rev.2.00 Jun.1, 2009
Page 22 of 228