R0E417250MCU00 Datasheet, PDF (29/228 Pages) Renesas Technology Corp – E100 Emulator MCU Unit for H8SX/1700 Series

R0E417250MCU00 User’s Manual
2. Setup
2.7 Self-checking
Self-checking is to check if the emulator functions operate properly. To run the self-check function of the emulator, follow the
procedure below. While self-checking is in progress, the states of the LEDs will change as shown in Figure 2.6. In case of
ERROR, because the states of the target status LEDs will change depending on the types of errors, check the system status
LEDs.
(1) If the user system is connected, disconnect it.
(2) Turn on the emulator.
(3) Launch the emulator debugger, and select the “Start booting up on successful completion of self-checking” checkbox in the
Device setting dialog box.
(4) When you click OK, self-checking will start. If the normal result is displayed in about 60 seconds, self-checking has ended.
SYSTEM
POWER
SAFE
SYSTEM
POWER
SAFE
TARGET
POWER
RESET
RUN
Emulator turned on
: ON
: OFF
: Flashing
: ON or OFF
: Undefined
TARGET
POWER
RESET
RUN
Self-checking has started
or
Self-checking is in progress
SYSTEM
POWER
SAFE
TARGET
POWER
RESET
RUN
Self-checking has normally ended
SYSTEM
POWER
SAFE
TARGET
POWER
RESET
RUN
Figure 2.6 LEDs during self-checking
Self-check error
Note:
See the error message on the debugger
REJ10J1831-0200 Rev.2.00 Jun.1, 2009
Page 29 of 228