R0E417250MCU00 Datasheet, PDF (132/228 Pages) Renesas Technology Corp – E100 Emulator MCU Unit for H8SX/1700 Series

R0E417250MCU00 User’s Manual
5. Debugging Functions
(3) ^{Other conditions}
You can select one from among five available choices: AND (cumulative), AND (simultaneous), Subroutine, Sequential and
State transitions. To set any condition, select the checkbox to the left of “Other conditions.”
Other conditions are disabled by default (the checkbox to the left of “Other conditions” is not selected). Cumulative AND is
listed as “AND(Accumulation)” in the dialog box.
Figure 5.52 Trace conditions dialog box
Table 5.21 Other conditions
Type
Description
AND (cumulative)
A trace point is encountered when all of the specified events have occurred, regardless of the
timing.
AND (simultaneous) A trace point is encountered when all of the specified events occur at the same time.
Subroutine
A trace point is encountered when a specified event occurs within a specified address range
(subroutine or function).
Sequential
6 steps (forward direction) + reset point
A trace point is encountered when the specified events occur in a specified order.
State transitions
3 steps, 9 paths + reset point
A trace point is encountered when the specified events occur in a specified order.
REJ10J1831-0200 Rev.2.00 Jun.1, 2009
Page 132 of 228