R0E417250MCU00 Datasheet, PDF (79/228 Pages) Renesas Technology Corp – E100 Emulator MCU Unit for H8SX/1700 Series

R0E417250MCU00 User’s Manual
5. Debugging Functions
5.1 Setting Up the Emulation Enviroment
When the emulator is connected, the Device setting and the Configuration properties dialog boxes are displayed. Here, select
the general options associated with the emulator. Note that the target MCU to be debugged, etc. can only be set once each time
the emulator is booted-up.
5.1.1 Emulator Settings During Booting up
While the emulator is booting up, the following three dialog boxes are opened in sequence.
(1) Device setting dialog box
Use this dialog box to select the target MCU and establish communication.
This dialog box can be re-opened by selecting Emulator -> Device setting from the Setup menu after the emulator has been
booted up. In this case, however, be aware that changes of setting made after boot-up will not be reflected immediately but will
be set as initial values when the emulator is reconnected.
(2) Configuration properties dialog box
This dialog box is opened after the Device setting dialog box. Use this dialog box to make settings related to the emulator and
debugger functions.
This dialog box can be re-opened by selecting Emulator -> System from the Setup menu after the emulator has been booted up.
Settings for certain options in this dialog box can be changed after boot-up. Those that can be changed are active while those
that cannot are inactive (grayed out), but with their settings displayed.
(3) Connecting dialog box
This dialog box shows the progress of boot-up processing.
REJ10J1831-0200 Rev.2.00 Jun.1, 2009
Page 79 of 228