R0E417250MCU00 Datasheet, PDF (34/228 Pages) Renesas Technology Corp – E100 Emulator MCU Unit for H8SX/1700 Series

R0E417250MCU00 User’s Manual
2. Setup
2.9.1 Connection to a 100-pin 0.5-mm Pitch Pad Pattern
The following is a procedure of connection to a 100-pin 0.5-mm pitch pad pattern on the user system using the
R0E0100TNPFK00 (not included). For details on the R0E0100TNPFK00, refer to its user’s manual.
(1) Install the NQPACK100SD-ND, which comes with the R0E0100TNPFK00, on the user system.
(2) Connect the YQPACK100SD, which also comes with the R0E0100TNPFK00, to the NQPACK100SD-ND and secure it
with the YQ-GUIDEs.
(3) Connect the R0E0100TNPFK00 to the YQPACK100SD.
(4) Connect CN2 of the R0E0100TNPFK00 to CN2 of the flexible cable.
(5) Connect CN1 of the R0E0100TNPFK00 to CN1 of the flexible cable.
(4)
(5)
Evaluation with
the actual MCU
R0E0100TNPFK00
*
These corners
are not round.
(3)
YQ-GUIDE (x 4)
YQPACK100SD
HQPACK100SD
(not included)
(2) _{NQPACK100SD-ND}
Flash MCU
(1)
100-pin 0.5-mm pitch
(PLQP0100KB-A) pad pattern
Pin 1
User system
*: These four products are available in one package.
Figure 2.11 Connection to a 100-pin 0.5-mm pitch pad pattern
CAUTION
Notes on Connecting the User System:
z Take care not to attach a converter board in a wrong direction. It may cause a fatal damage to the emulator and
user system.
z The connectors of the R0E0100TNPFK00 are guaranteed for only 50 insertion/removal iterations.
z For purchasing the HQPACK100SD, contact the following:
Tokyo Eletech Corporation http://www.tetc.co.jp/e_index.htm
REJ10J1831-0200 Rev.2.00 Jun.1, 2009
Page 34 of 228