R0E417250MCU00 Datasheet, PDF (134/228 Pages) Renesas Technology Corp – E100 Emulator MCU Unit for H8SX/1700 Series

R0E417250MCU00 User’s Manual
5. Debugging Functions
5.9.6 Setting Extraction or Elimination Conditions
If the selected trace mode is Fill until stop, Fill until full or Fill around TP, you can specify a condition for capturing or not
capturing information.
You can specify events so as to extract only the required portions or to eliminate non-required portions of the trace information.
(1) ^{Extraction and elimination conditions}
The following types of condition are available.
Table 5.22 Extraction and elimination conditions
Type
Extraction
Between two events
Elimination
Duration of an event
Duration of an event
occurring in a
subroutine
Instruction accessing
specific data
Between two events
Duration of an event
Duration of an event
occurring in a
subroutine
Description
Trace information is extracted from the cycle in which the
event set as [Start event] occurs to the cycle preceding the
event set as [End event] (information is not acquired for the
cycle where [End event] occurs).
Trace information is extracted over the cycles
corresponding to occurrence of the specified event.
Trace information is extracted over the cycles
corresponding to occurrence of the specified event within
the specified address range (subroutine or function).
Information is extracted for instructions that access
specified data.
Trace information is eliminated from the cycle in which the
event set as [Start event] occurs to the cycle preceding the
event set as [End event] (information is not acquired for the
cycle where [End event] occurs).
Trace information is eliminated over the cycles
corresponding to occurrence of the specified event.
Trace information is eliminated over the cycles
corresponding to occurrence of the specified event within
the specified address range (subroutine or function).
Select the desired condition from the list box that is displayed when you select Capture or Do not capture in the Record
condition group box of the Trace conditions dialog box.
Figure 5.54 Record condition group box
Then click on the Detail button. The Event dialog box will appear.
REJ10J1831-0200 Rev.2.00 Jun.1, 2009
Page 134 of 228