R0E417250MCU00 Datasheet, PDF (225/228 Pages) Renesas Technology Corp – E100 Emulator MCU Unit for H8SX/1700 Series

R0E417250MCU00 User’s Manual
8. Maintenance and
8. Maintenance and Warranty
This chapter covers basic maintenance, warranty information, provisions for repair and the procedures for requesting a repair.
8.1 User Registration
When you purchase our product, be sure to register as a user. For user registration, refer to “User Registration” (page 14) of
this user's manual.
8.2 Maintenance
(7) (1) If dust or dirt collects anywhere on your emulation system, wipe it off with a dry soft cloth. Do not use thinner or
other solvents because these chemicals can cause the equipment's surface coating to separate.
(8) (2) When you do not use the MCU unit for a long period, for safety purposes, disconnect the power cable from the power
supply.
8.3 Warranty
If your product becomes faulty within one year after purchase while being used under conditions of observance of the
"IMPORTANT" and "Precautions for Safety" notes in this user's manual, we will repair or replace your faulty product free of
charge. Note, however, that if your product's fault is due to any of the following causes, an extra charge will apply to our repair
or replacement of the product.
- Misuse, abuse, or use under extraordinary conditions
- Unauthorized repair, remodeling, maintenance, and so on
- Inadequate user system or improper use of the user system
- Fires, earthquakes, and other unexpected disasters
In the above cases, contact your local distributor. If your product is being leased, consult the leasing company or the owner.
8.4 Repair Provisions
(1) Repairs not covered by warranty
Problems arising in products for which more than one year has elapsed since purchase are not covered by warranty.
(2) Replacement not covered by warranty
If your product's fault falls into any of the following categories, the fault will be corrected by replacing the entire product
instead of repairing it, or you will be advised to purchase a new product, depending on the severity of the fault.
- Faulty or broken mechanical portions
- Flaws, separation, or rust in coated or plated portions
- Flaws or cracks in plastic portions
- Faults or breakage caused by improper use or unauthorized repair or modification
- Heavily damaged electric circuits due to overvoltage, overcurrent or shorting of power supply
- Cracks in the printed circuit board or burnt-down patterns
- A wide range of faults that make replacement less expensive than repair
- Faults that are not locatable or identifiable
REJ10J1831-0200 Rev.2.00 Jun.1, 2009
Page 225 of 228