R0E417250MCU00 Datasheet, PDF (206/228 Pages) Renesas Technology Corp – E100 Emulator MCU Unit for H8SX/1700 Series

R0E417250MCU00 User’s Manual
5.16.4 Setting for Output through Trigger Pins 20 to 16
The Event output page allows manual setting for output through trigger pins 20 to 16.
5. Debugging Functions
Figure 5.127 Trigger Output Conditions dialog box (Event output page)
(1) Default setting
‘Default setting’ indicates the trigger output conditions on pins 23 to 21. These pins are always enabled. Signals are output
through these pins when the respective conditions are satisfied. Table 5.47 gives details on how the conditions control output.
Table 5.47 Trigger Output Conditions and Output
No.
Condition
Output
23
A breakpoint is
Continued output of a high-level signal is started.
encountered
22
A trace point is
encountered
A high-level signal is output only during cycles in which the
trace-point condition is satisfied.
21
Specific trace data is A high-level signal is output only in cycles where trace data is
extracted or deleted being extracted or discarded.
REJ10J1831-0200 Rev.2.00 Jun.1, 2009
Page 206 of 228