CP3BT10 Datasheet, PDF (183/210 Pages) National Semiconductor (TI) – Reprogrammable Connectivity Processor with Bluetooth and USB Interfaces

Symbol
Parameter
Iccprog Digital Supply Current Active Mode ^d
Iccps Digital Supply Current Power Save Mode ^e
Iccid
Digital Supply Current Idle Mode ^f
Iccq
Digital Supply Current Halt Mode ^f,g,h
Conditions
Vcc = 2.75V,
IOVcc = 3.63V
Vcc = 2.75V,
IOVcc = 3.63V
Vcc = 2.75V,
IOVcc = 3.63V
Vcc = 2.75V,
IOVcc = 3.63V
Min
Max
Units
15
mA
4.0
mA
950
µA
700
µA
a. Guaranteed by design
b. Test code executing from internal RAM. No peripheral blocks other than PLL and Auxiliary Clock enabled.
X1CLKI is 24 MHz. Not programming Flash memory. Typical applications will show 16 mA (Icca1 + 4 mA) at
24 MHz executing code from flash memory.
c. Waiting for interrupt on executing WAIT instruction, Iout = 0 mA, X1CKI = 12 MHz, PLL enabled (4×), internal
system clock is 24 MHz, not programming Flash memory
d. Same conditions as Icca1, but programming or erasing Flash memory page
e. Running from internal memory (RAM), Iout = 0 mA, XCKI1 = 12 MHz, PLL disabled, X2CKI = 32.768 kHz,
device put in power-save mode, Slow Clock derived from XCKI1
f. Iout = 0 mA, XCKI1 = off, X2CKI = 32.768 kHz
g. USB switched off (suspend)
h. Halt current approximately doubles for every 20°C.
27.3 USB TRANSCEIVER ELECTRICAL CHARACTERISTICS (Temperature: -40°C ≤ T_A ≤ +85°C)
Symbol
Parameter
V_DI
V_CM
V_SE
V_OL
V_OH
V_OZ
C_TRN
Differential Input Sensitivity
Differential Common Mode Range
Single-Ended Receiver Threshold
Output Low Voltage
Output High Voltage
TRI-STATE Data Line Leakage
Transceiver Capacitance
Conditions
(D+) - (D-)
R_L = 1.5K ohm to 3.6V
0V < V_IN < 3.3V
Min
Max Units
-0.2
0.2 V
0.8
2.5 V
0.8
2.0 V
0.3 V
2.8
V
-10
10 µA
20 pF
183
www.national.com