MC9S08QG8 Datasheet, PDF (264/300 Pages) Freescale Semiconductor, Inc – 8-BIT HCS08 Central Processor Unit

Appendix A Electrical Characteristics
0.8
TYPICAL V_DD – V_OH VS I_OH AT V_DD = 3.0 V
85°C
0.6
25°C
–40°C
0.4
0.2
TYPICAL V_DD – V_OH VS V_DD AT SPEC I_OH
0.4
85°C
25°C
0.3
–40°C
0.2
I_OH = –10 mA
0.1
I_OH = –6 mA
I_OH = –3 mA
0
0
0
–5
–10
–15
–20
–25
–30
1
2
3
4
I_OH (mA)
V_DD (V)
Figure A-5. Typical High-Side (Source) Characteristics — High Drive (PTxDSn = 1)
A.6 Supply Current Characteristics
This section includes information about power supply current in various operating modes.
Table A-6. Supply Current Characteristics
Parameter
Run supply current ³ measured in FBE mode at
f_Bus = 8 MHz
Run supply current ³ measured in FBE mode at
f_Bus = 1 MHz
Symbol
RI_DD
RI_DD
V_DD (V)¹
3
2
3
2
Typical²
3.5 mA
2.6 mA
490 µA
370 µA
Max
5 mA
—
1 mA
—
T (°C)
85
85
85
85
Wait mode supply current ⁴ measured in FBE at 8 MHz
WI_DD
3
1 mA
1.5 mA
85
Stop1 mode supply current
S1I_DD
3
475 nA
1.2 µA
85
2
470 nA
—
85
Stop2 mode supply current
3
600 nA
2 µA
85
S2I
DD
2
550 nA
—
85
Stop3 mode supply current
3
750 nA
6 µA
85
S3I_DD
2
680 nA
—
85
RTI adder to stop1, stop2 or stop3 ⁴
3
300 nA
—
85
—
2
300 nA
—
85
LVD adder to stop3 (LVDE = LVDSE = 1)
3
70 µA
—
85
—
2
60 µA
—
85
Adder to stop3 for oscillator enabled ⁵
(EREFSTEN =1)
3
5 µA
—
85
—
2
4 µA
—
85
1 _{3-V values are 100% tested; 2-V values are characterized but not tested.}
2 _{Typicals are measured at 25°C.}
3 _{Does not include any DC loads on port pins.}
4 _{Most customers are expected to find that auto-wakeup from a stop mode can be used instead of the higher current wait mode.}
5 _{Values given under the following conditions: low range operation (RANGE = 0), Loss-of-clock disabled (LOCD = 1), low-power}
oscillator (HGO = 0).
MC9S08QG8 and MC9S08QG4 Data Sheet, Rev. 1.01
264
Freescale Semiconductor