MC908AS60ACFU Datasheet, PDF (210/414 Pages) Freescale Semiconductor, Inc – M68HC08 Microcontrollers

Serial Peripheral Interface (SPI)
19.5.2 Transmission Format When CPHA = 0
Figure 19-4 shows an SPI transmission in which CPHA (SPCR) is logic 0. The figure should not be used
as a replacement for data sheet parametric information. Two waveforms are shown for SCK: one for
CPOL = 0 and another for CPOL = 1. The diagram may be interpreted as a master or slave timing
diagram since the serial clock (SCK), master in/slave out (MISO), and master out/slave in (MOSI) pins
are directly connected between the master and the slave. The MISO signal is the output from the slave,
and the MOSI signal is the output from the master. The SS line is the slave select input to the slave. The
slave SPI drives its MISO output only when its slave select input (SS) is low, so that only the selected
slave drives to the master. The SS pin of the master is not shown but is assumed to be inactive. The SS
pin of the master must be high or must be reconfigured as general-purpose I/O not affecting the SPI (see
19.6.2 Mode Fault Error). When CPHA = 0, the first SPSCK edge is the MSB capture strobe. Therefore,
the slave must begin driving its data before the first SPSCK edge, and a falling edge on the SS pin is used
to start the transmission. The SS pin must be toggled high and then low again between each byte
transmitted.
SCK CYCLE #
FOR REFERENCE
1
2
3
4
5
6
7
8
SCK CPOL = 0
SCK CPOL = 1
MOSI
FROM MASTER
MISO
FROM SLAVE
SS TO SLAVE
CAPTURE STROBE
MSB
BIT 6
BIT 5
BIT 4
BIT 3
BIT 2
BIT 1
LSB
MSB
BIT 6
BIT 5
BIT 4
BIT 3
BIT 2
BIT 1
LSB
Figure 19-4. Transmission Format (CPHA = 0)
MC68HC908AZ60A • MC68HC908AS60A • MC68HC908AS60E Data Sheet, Rev. 6
210
Freescale Semiconductor