MC908AS60ACFU Datasheet, PDF (136/414 Pages) Freescale Semiconductor, Inc – M68HC08 Microcontrollers

Clock Generator Module (CGM)
10.5 CGM Registers
Three registers control and monitor operation of the CGM:
• PLL control register (PCTL)
• PLL bandwidth control register (PBWC)
• PLL programming register (PPG)
10.5.1 PLL Control Register
The PLL control register contains the interrupt enable and flag bits, the on/off switch, and the base clock
selector bit.
Address: $001C
Bit 7
6
5
4
3
2
1
Bit 0
Read:
PLLF
1
1
1
1
PLLIE
PLLON
BCS
Write:
Reset: 0
0
1
0
1
1
1
1
= Unimplemented
Figure 10-4. PLL Control Register (PCTL)
PLLIE — PLL Interrupt Enable Bit
This read/write bit enables the PLL to generate a CPU interrupt request when the LOCK bit toggles,
setting the PLL flag, PLLF. When the AUTO bit in the PLL bandwidth control register (PBWC) is clear,
PLLIE cannot be written and reads as logic 0. Reset clears the PLLIE bit.
1 = PLL CPU interrupt requests enabled
0 = PLL CPU interrupt requests disabled
PLLF — PLL Flag Bit
This read-only bit is set whenever the LOCK bit toggles. PLLF generates a CPU interrupt request if the
PLLIE bit also is set. PLLF always reads as logic 0 when the AUTO bit in the PLL bandwidth control
register (PBWC) is clear. Clear the PLLF bit by reading the PLL control register. Reset clears the PLLF
bit.
1 = Change in lock condition
0 = No change in lock condition
NOTE
Do not inadvertently clear the PLLF bit. Be aware that any read or
read-modify-write operation on the PLL control register clears the PLLF bit.
PLLON — PLL On Bit
This read/write bit activates the PLL and enables the VCO clock, CGMVCLK. PLLON cannot be
cleared if the VCO clock is driving the base clock, CGMOUT (BCS = 1). See 10.3.3 Base Clock
Selector Circuit. Reset sets this bit so that the loop can stabilize as the MCU is powering up.
1 = PLL on
0 = PLL off
BCS — Base Clock Select Bit
This read/write bit selects either the crystal oscillator output, CGMXCLK, or the VCO clock,
CGMVCLK, as the source of the CGM output, CGMOUT. CGMOUT frequency is one-half the
frequency of the selected clock. BCS cannot be set while the PLLON bit is clear. After toggling BCS,
MC68HC908AZ60A • MC68HC908AS60A • MC68HC908AS60E Data Sheet, Rev. 6
136
Freescale Semiconductor