S6J3200 Datasheet, PDF (72/179 Pages) Cypress Semiconductor – 32-bit Microcontroller Traveo꽬 Family

S6J3200 Series
Parameter
Symbol
Rating
Unit
Min
Max
Remarks
System Thermal Resistance
Theta j-a
-
16
o_C/W
Package Thermal Resistance
Storage temperature
Theta j-c
Tstg
-
7.5
o_C/W
-55
+150
o_C
*1: These parameters are based on the condition that VSS=AVSS=DVSS=0.0 V.
The minimum value depends
on the system specification of
heat radiation. The described
value is estimated under the
condition which is specified at
Operation Assurance
Condition.
-
-
*2: Take care that DVCC, AVCC5 do not exceed VCC5 at, for example, the power-on time.
*3: The maximum output current is defined as the value of the peak current flowing through any
one of the corresponding pins.
*4: The average output current is defined as the value of the average current flowing through any
one of the corresponding pins for a 10 ms period. The average value is the operation current ×
the operation ratio.
*5: The total output current is defined as the maximum current value flowing through all of
corresponding pins.
*6: Output of 5V pins.
*7: Output of SMC pins.
*8: Output of 5V/3V pins.
*9: Output of 3V pins.
*10: Output of I²C.
*11: Output of Media LB pins
*12: VI or VO should never exceed the specified ratings. However, if the maximum current to/from
an input is limited by a suitable external resistor, the ICLAMP rating supersedes the VI rating.
*A: Relevant pins: All general-purpose ports and analog input pins
• Corresponding pins : all general-purpose ports
• Use within the operation assurance condition (See 8.2. Operation Assurance ).
• Use at DC voltage (current).
• The +B signal should always be applied by connecting a limiting resistor between the +B signal and the microcontroller.
• The value of the limiting resistor should be set so that the current input to the microcontroller pin does not exceed rated values
at any time regardless of instantaneously or constantly when the +B signal is input.
• Note that when the microcontroller drive current is low, such as in the low power consumption modes, the + B input potential
can increase the potential at the VCC pin via a protective diode, possibly affecting other devices.
• Note that if the + B signal is input when the microcontroller is off (not fixed at 0 V), since the power is supplied through the pin,
the microcontroller may operate incompletely.
• Note that if the +B signal is input at power-on, since the power is supplied through the pin, the power-on reset may not function
in the power supply voltage.
• Do not leave + B input pins open.
Document Number: 002-05682 Rev.*A
Page 72 of 179