GC5018_06 Datasheet, PDF (85/134 Pages) Texas Instruments – 8-CHANNEL WIDEBAND RECEIVER

www.ti.com
4.4.4.18 RAGC1_INTEGINVL_LSB Register
GC5018
8-CHANNEL WIDEBAND RECEIVER
SLWS169A – MAY 2005 – REVISED NOVEMBER 2005
Register name: RAGC1_INTEGINVL_LSB
BIT 15
0
0
0
BIT 7
0
0
0
Page: 0x1840 Address: 0x11
integ_interval_1(15:8)
0
0
0
0
integ_interval_1(7:0)
0
0
0
0
integ_interval_1(15:0) : The LSBs of the integration time for receive AGC 1
4.4.4.19 RAGC1_INTEGINVL_MSB Register
BIT 8
0
BIT 0
0
Register name: RAGC1_INTEGINVL_MSB
BIT 15
0
0
0
BIT 7
0
0
0
Page: 0x1840 Address: 0x12
ragc_update_1(7:0)
0
0
0
0
integ_interval_1(23:16)
0
0
0
0
BIT 8
0
BIT 0
0
ragc_update_1(7:0) : Sets the number of receive AGC updates per sync event (0x00 is infinite).
integ_interval_1(23:16) : The MSBs of the integration time for receive AGC 1
4.4.4.20 RAGC1_CONFIG0 Register
Register name: RAGC1_CONFIG0
BIT 15
0
0
0
BIT 7
hp_corner_1(2:0)
0
0
0
Page: 0x1840 Address: 0x13
ragc_sync_delay_1(7:0)
0
0
0
0
acc_shift_1(4:0)
0
0
0
0
BIT 8
0
BIT 0
0
ragc_sync_delay_1(7:0) : The input sync to the receive AGC block is delayed by this value of samples.
hp_corner_1(2:0) : This sets the corner frequency of the High Pass filter. Larger values result in higher
corner frequencies.
acc_shift_1(4:0) : Selects the integrated power measurements result bits to be used as the error lookup
table address. A larger number means fewer samples will have to be integrated to achieve
the same result.
GC5018 GENERAL CONTROL
85