HD64F36024FX Datasheet, PDF (375/386 Pages) Renesas Technology Corp – Old Company Name in Catalogs and Other Documents

Main Revisions and Additions in this Edition
Item
Page Revision (See Manual for Details)
Preface
vi, vii When using the on-chip emulator (E7, E8) for H8/36014
program development and debugging, the following
restrictions must be noted.
1. The NMI pin is reserved for the E7 or E8, and cannot be
used.
2. Area H'7000 to H'7FFF is used by the E7 or E8, and is not
available to the user.
4. When the E7 or E8 is used, address breaks can be set as
either available to the user or for use by the E7 or E8. If
address breaks are set as being used by the E7 or E8, the
address break control registers must not be accessed.
5. When the E7 or E8 is used, NMI is an input/output pin
(open-drain in output mode).
6. Use channel 1 of the SCI3 (P21/RXD, P22/TXD) in on-
board programming mode by boot mode.
Note has been deleted.
Section 1 Overview
3
3 Can also be used for the E7 or E8 emulator.
1.2 Internal Block Diagram
Figure 1.1 Internal Block
Diagram
Figure 1.2 Pin
4
2 Can also be used for the E7 or E8 emulator.
Arrangement (FP-64E)
Figure 1.3 Pin
5
Arrangement (FP-48F, FP-
48B, TNP-48)
2 Can also be used for the E7 or E8 emulator.
Table 1.1 Pin Functions 7
Type Functions
E10T Interface pin for the E10T, E8, or E7 emulator
Section 7 ROM
Section 8 RAM
77 The features of the 32-kbyte (4 kbytes of them are the control
program area for E7 or E8) flash memory built into the
HD64F36024 and HD64F36014 are summarized below.
93 Note: When the E7 or E8 is used, area H'F780 to H'FB7F
must not be accessed.
Rev. 4.00 Sep. 23, 2005 Page 347 of 354
REJ09B0025-0400