MC68HC908GP32 Datasheet, PDF (75/410 Pages) Motorola, Inc – M68HC08 Family of 8-bit microcontroller units (MCUs)

Freescale Semiconductor, Inc.
Resets and Interrupts
Resets
4.3.3.2 COP Reset
A COP reset is an internal reset caused by an overflow of the COP
counter. A COP reset sets the COP bit in the system integration module
(SIM) reset status register.
To clear the COP counter and prevent a COP reset, write any value to
the COP control register at location $FFFF.
4.3.3.3 Low-Voltage Inhibit Reset
A low-voltage inhibit (LVI) reset is an internal reset caused by a drop in
the power supply voltage to the LVI_tripf voltage.
An LVI reset:
• Holds the clocks to the CPU and modules inactive for an oscillator
stabilization delay of 4096 CGMXCLK cycles after the power
supply voltage rises to the LVI_tripr voltage
• Drives the RST pin low for as long as V_DD is below the LVI_tripr
voltage and during the oscillator stabilization delay
• Releases the RST pin 32 CGMXCLK cycles after the oscillator
stabilization delay
• Releases the CPU to begin the reset vector sequence
64 CGMXCLK cycles after the oscillator stabilization delay
• Sets the LVI bit in the SIM reset status register
4.3.3.4 Illegal Opcode Reset
An illegal opcode reset is an internal reset caused by an opcode that is
not in the instruction set. An illegal opcode reset sets the ILOP bit in the
SIM reset status register.
If the stop enable bit, STOP, in the mask option register is a logic 0, the
STOP instruction causes an illegal opcode reset.
MC68HC908GP32•MC68HC08GP32 — Rev. 6
MOTOROLA
Resets and Interrupts
For More Information On This Product,
Go to: www.freescale.com
Technical Data
73