MC68HC908GP32 Datasheet, PDF (259/410 Pages) Motorola, Inc – M68HC08 Family of 8-bit microcontroller units (MCUs)

Freescale Semiconductor, Inc.
Serial Communications Interface Module (SCI)
Low-Power Modes
• Framing error (FE) — The FE bit in SCS1 is set when a logic 0
occurs where the receiver expects a stop bit. The framing error
interrupt enable bit, FEIE, in SCC3 enables FE to generate SCI
error CPU interrupt requests.
• Parity error (PE) — The PE bit in SCS1 is set when the SCI
detects a parity error in incoming data. The parity error interrupt
enable bit, PEIE, in SCC3 enables PE to generate SCI error CPU
interrupt requests.
18.6 Low-Power Modes
The WAIT and STOP instructions put the MCU in low power-
consumption standby modes.
18.6.1 Wait Mode
The SCI module remains active after the execution of a WAIT
instruction. In wait mode, the SCI module registers are not accessible by
the CPU. Any enabled CPU interrupt request from the SCI module can
bring the MCU out of wait mode.
If SCI module functions are not required during wait mode, reduce power
consumption by disabling the module before executing the WAIT
instruction.
Refer to Section 3. Low-Power Modes for information on exiting wait
mode.
18.6.2 Stop Mode
The SCI module is inactive after the execution of a STOP instruction.
The STOP instruction does not affect SCI register states. SCI module
operation resumes after an external interrupt.
Because the internal clock is inactive during stop mode, entering stop
mode during an SCI transmission or reception results in invalid data.
Refer to Section 3. Low-Power Modes for information on exiting stop
mode.
MC68HC908GP32•MC68HC08GP32 — Rev. 6
MOTOROLA
Serial Communications Interface Module (SCI)
For More Information On This Product,
Go to: www.freescale.com
Technical Data
257