English
Language : 

PIC24FJ16MC101_12 Datasheet, PDF (65/350 Pages) Microchip Technology – 16-bit Microcontrollers (up to 32 KB Flash and 2 KB SRAM)
PIC24FJ16MC101/102 AND PIC24FJ32MC101/102/104
6.1 System Reset
The PIC24FJ16MC101/102 and PIC24FJ32MC101/102/
104 family of devices have two types of Reset:
• Cold Reset
• Warm Reset
A cold Reset is the result of a POR or a BOR. On a cold
Reset, the FNOSC configuration bits in the FOSC
device configuration register selects the device clock
source.
A warm Reset is the result of all other Reset sources,
including the RESET instruction. On warm Reset, the
device will continue to operate from the current clock
source as indicated by the Current Oscillator Selection
bits (COSC<2:0>) in the Oscillator Control register
(OSCCON<14:12>).
The device is kept in a Reset state until the system
power supplies have stabilized at appropriate levels
and the oscillator clock is ready. The sequence in
which this occurs is shown in Figure 6-2.
TABLE 6-1: OSCILLATOR DELAY
Oscillator Mode
Oscillator
Startup Delay
Oscillator Startup
Timer
PLL Lock Time
Total Delay
FRC, FRCDIV16, FRCDIVN
TOSCD
—
—
TOSCD
FRCPLL
TOSCD
—
TLOCK
TOSCD + TLOCK
MS
TOSCD
TOST
—
TOSCD + TOST
HS
TOSCD
TOST
—
TOSCD + TOST
EC
—
—
—
—
MSPLL
TOSCD
TOST
TLOCK
TOSCD + TOST + TLOCK
ECPLL
—
—
TLOCK
TLOCK
SOSC
TOSCD
TOST
—
TOSCD + TOST
LPRC
TOSCD
—
—
TOSCD
Note 1: TOSCD = Oscillator Start-up Delay (1.1 μs max for FRC, 70 μs max for LPRC). Crystal Oscillator start-up
times vary with crystal characteristics, load capacitance, etc.
2: TOST = Oscillator Start-up Timer Delay (1024 oscillator clock period). For example, TOST = 102.4 μs for a
10 MHz crystal and TOST = 32 ms for a 32 kHz crystal.
3: TLOCK = PLL lock time (1.5 ms nominal), if PLL is enabled.
© 2011-2012 Microchip Technology Inc.
Preliminary
DS39997C-page 65