PIC24FJ16MC101_12 Datasheet, PDF (267/350 Pages) Microchip Technology – 16-bit Microcontrollers (up to 32 KB Flash and 2 KB SRAM)

PIC24FJ16MC101/102 AND PIC24FJ32MC101/102/104
TABLE 26-12: DC CHARACTERISTICS: PROGRAM MEMORY
DC CHARACTERISTICS
Standard Operating Conditions: 3.0V to 3.6V
(unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for Industrial
-40°C ≤ TA ≤ +125°C for Extended
Param
No.
Symbol
Characteristic⁽³⁾
Min Typ⁽¹⁾ Max Units
Conditions
Program Flash Memory
D130a EP
Cell Endurance
10,000 —
— E/W -40°C to +125°C
D131 VPR
VDD for Read
VMIN —
3.6
V VMIN = Minimum operating
voltage
D132B VPEW VDD for Self-Timed Write
VMIN —
3.6
V VMIN = Minimum operating
voltage
D134 TRETD Characteristic Retention
20
—
— Year Provided no other specifications
are violated
D135 IDDP
Supply Current during
Programming
—
10
— mA
D137a TPE Page Erase Time
20.1 — 26.5 ms TPE = 168517 FRC cycles,
TA = +100°C, See Note 2
D137b TPE Page Erase Time
19.5 — 27.3 ms TPE = 168517 FRC cycles,
TA = +125°C, See Note 2
D138a TWW Word Write Cycle Time
47.6 —
49
µs TWW = 355 FRC cycles,
TA = +100°C, See Note 2
D138b TWW Word Write Cycle Time
47.4 — 49.3 µs TWW = 355 FRC cycles,
TA = +125°C, See Note 2
Note 1: Data in “Typ” column is at 3.3V, 25°C unless otherwise stated.
2: Other conditions: FRC = 7.37 MHz, TUN<5:0> = b'011111 (for Min), TUN<5:0> = b'100000 (for Max).
This parameter depends on the FRC accuracy (see Table 26-18) and the value of the FRC Oscillator
Tuning register (see Register 8-3). For complete details on calculating the Minimum and Maximum time
see Section 5.3 “Programming Operations”.
3: These parameters are ensured by design, but are not characterized or tested in manufacturing.
TABLE 26-13: INTERNAL VOLTAGE REGULATOR SPECIFICATIONS
DC CHARACTERISTICS
Standard Operating Conditions: 3.0V to 3.6V
(unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for Industrial
-40°C ≤ TA ≤ +125°C for Extended
Param
No.
Symbol
Characteristics
Min Typ Max Units
Comments
— _CEFC
External Filter Capacitor
Value⁽¹⁾
4.7
10
—
µF Capacitor must be low
series resistance
(< 5 ohms)
Note 1: Typical VCAP voltage = 2.5V when VDD ≥ VDDMIN.
© 2011-2012 Microchip Technology Inc.
Preliminary
DS39997C-page 267