PIC18FXX39 Datasheet, PDF (265/322 Pages) Microchip Technology – Enhanced FLASH Microcontrollers with Single Phase Induction Motor Control Kernel

PIC18FXX39
23.2 DC Characteristics: PIC18FXX39 (Industrial, Extended)
PIC18LFXX39 (Industrial) (Continued)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C TA  +85°C for industrial
-40°C TA  +125°C for extended
Param
No.
Symbol
Characteristic
Min
Max Units
Conditions
VOL Output Low Voltage
D080
D080A
VOH
D090
D090A
I/O ports
Output High Voltage⁽²⁾
I/O ports
—
0.6
—
0.6
VDD – 0.7
—
VDD – 0.7
—
V IOL = 8.5 mA, VDD = 4.5V,
-40C to +85C
V IOL = 7.0 mA, VDD = 4.5V,
-40C to +125C
V IOH = -3.0 mA, VDD = 4.5V,
-40C to +85C
V IOH = -2.5 mA, VDD = 4.5V,
-40C to +125C
D150 VOD
D100⁽³⁾ COSC2
Open Drain High Voltage
Capacitive Loading Specs
on Output Pins
OSC2 pin
—
8.5
V RA4 pin
—
15
pF In HS mode when external
clock is used to drive OSC1
D101 CIO
D102 CB
All I/O pins
SCL, SDA
—
50
pF To meet the AC Timing
Specifications
—
400
pF In I²C mode
Note 1: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input
voltages.
2: Negative current is defined as current sourced by the pin.
3: Parameter is characterized but not tested.
 2002-2013 Microchip Technology Inc.
Preliminary
DS30485B-page 265