PIC18FXX39 Datasheet, PDF (1/322 Pages) Microchip Technology – Enhanced FLASH Microcontrollers with Single Phase Induction Motor Control Kernel

PIC18FXX39
Enhanced FLASH Microcontrollers with
Single Phase Induction Motor Control Kernel
High Performance RISC CPU:
• Linear program memory addressing to 24 Kbytes
• Linear data memory addressing to 1.4 Kbytes
• 20 MHz operation (5 MIPs):
- 20 MHz oscillator/clock input
- 5 MHz oscillator/clock input with PLL active
• 16-bit wide instructions, 8-bit wide data path
• 8 x 8 Single Cycle Hardware Multiplier
Special Microcontroller Features:
• 100,000 erase/write cycle Enhanced FLASH
program memory typical
• 1,000,000 erase/write cycle Data EEPROM memory
• FLASH/Data EEPROM Retention: > 100 years
• Power-on Reset (POR), Power-up Timer (PWRT)
and Oscillator Start-up Timer (OST)
• Programmable code protection
• Power saving SLEEP mode
• Single supply 5V In-Circuit Serial Programming™
(ICSP™) via two pins
• In-Circuit Debug (ICD) via two pins
Analog Features:
• Compatible 10-bit Analog-to-Digital Converter
module (A/D) with:
- Fast sampling rate
- Conversion available during SLEEP
- DNL = ±1 LSb, INL = ±1 LSb
• Programmable Low Voltage Detection (PLVD)
- Supports interrupt on Low Voltage Detection
• Programmable Brown-out Reset (BOR)
Peripheral Features:
• High current sink/source 25 mA/25 mA
• Three external interrupt pins
• Timer0 module: 8-bit/16-bit timer/counter with
8-bit programmable prescaler
• Timer1 module: 16-bit timer/counter
• Timer3 module: 16-bit timer/counter
• Secondary oscillator clock option - Timer1/Timer3
• Two PWM modules:
- Resolution is 1- to 10-bit,
Max. PWM freq. @ 8-bit resolution = 156 kHz
10-bit resolution = 39 kHz
• Single Phase Induction Motor Control kernel
- Programmable Motor Control Technology
(ProMPT™) provides open loop Variable
Frequency (VF) control
- User programmable Voltage vs. Frequency
curve
- Most suitable for shaded pole and permanent
split capacitor type motors
• Master Synchronous Serial Port (MSSP) module
with two modes of operation:
- 3-wire SPI (supports all 4 SPI modes)
- I²C™ Master and Slave mode
• Addressable USART module:
- Supports RS-485 and RS-232
• Parallel Slave Port (PSP) module
CMOS Technology:
• Low power, high speed FLASH/EEPROM
technology
• Fully static design
• Wide operating voltage range (2.0V to 5.5V)
• Industrial and Extended temperature ranges
Device
PIC18F2439
PIC18F2539
PIC18F4439
PIC18F4539
Program Memory
Bytes Words
12K 6144
24K 12288
12K 6144
24K 12288
Data Memory
I/O 10-bit
SRAM EEPROM _{Pins A/D (ch)}
(Bytes) (Bytes)
640
256 21
5
1408
256 21
5
640
256 32
8
1408
256 32
8
PWM
10-bit
2
2
2
2
MSSP
SPI
Master
I²C
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
AUSART
Timers
16-bit/WDT
Yes
3/1
Yes
3/1
Yes
3/1
Yes
3/1
 2002-2013 Microchip Technology Inc.
Preliminary
DS30485B-page 1