PIC18FXX39 Datasheet, PDF (162/322 Pages) Microchip Technology – Enhanced FLASH Microcontrollers with Single Phase Induction Motor Control Kernel

PIC18FXX39
16.4.17.2 Bus Collision During a Repeated
START Condition
During a Repeated START condition, a bus collision
occurs if:
a) A low level is sampled on SDA when SCL goes
from low level to high level.
b) SCL goes low before SDA is asserted low, indi-
cating that another master is attempting to
transmit a data ‘1’.
When the user de-asserts SDA and the pin is allowed to
float high, the BRG is loaded with SSPADD<6:0> and
counts down to ‘0’. The SCL pin is then de-asserted,
and when sampled high, the SDA pin is sampled.
If SDA is low, a bus collision has occurred (i.e., another
master is attempting to transmit a data ’0’,
Figure 16-29). If SDA is sampled high, the BRG is
reloaded and begins counting. If SDA goes from high to
low before the BRG times out, no bus collision occurs
because no two masters can assert SDA at exactly the
same time.
If SCL goes from high to low before the BRG times out
and SDA has not already been asserted, a bus collision
occurs. In this case, another master is attempting to
transmit a data ‘1’ during the Repeated START
condition, see Figure 16-30.
If, at the end of the BRG time-out, both SCL and SDA
are still high, the SDA pin is driven low and the BRG is
reloaded and begins counting. At the end of the count,
regardless of the status of the SCL pin, the SCL pin is
driven low and the Repeated START condition is
complete.
FIGURE 16-29: BUS COLLISION DURING A REPEATED START CONDITION (CASE 1)
SDA
SCL
RSEN
Sample SDA when SCL goes high.
If SDA = 0, set BCLIF and release SDA and SCL.
BCLIF
S
SSPIF
Cleared in software
'0'
'0'
FIGURE 16-30:
SDA
SCL
BCLIF
RSEN
S
SSPIF
BUS COLLISION DURING REPEATED START CONDITION (CASE 2)
TBRG
TBRG
SCL goes low before SDA,
Set BCLIF. Release SDA and SCL.
Interrupt cleared
in software
'0'
DS30485B-page 162
Preliminary
 2002-2013 Microchip Technology Inc.