MC908GR32AVFAE Datasheet, PDF (48/314 Pages) Freescale Semiconductor, Inc – Microcontrollers

Memory
E. The time between each FLASH address change (step 7 to step 7), or the time between the last FLASH
address programmed to clearing the PGM bit (step 7 to step 10) must not exceed the maximum
programming time, t_PROG maximum.
F. Be cautious when programming the FLASH-1 array to ensure that non-FLASH locations are not used
as the address that is written to when selecting either the desired row address range in step 3 of the
algorithm or the byte to be programmed in step 7 of the algorithm.
2.6.7 Low-Power Modes
The WAIT and STOP instructions will place the MCU in low power-consumption standby modes.
2.6.7.1 Wait Mode
Putting the MCU into wait mode while the FLASH is in read mode does not affect the operation of the
FLASH memory directly; however, no memory activity will take place since the CPU is inactive.
The WAIT instruction should not be executed while performing a program or erase operation on the
FLASH. Wait mode will suspend any FLASH program/erase operations and leave the memory in a
standby mode.
2.6.7.2 Stop Mode
Putting the MCU into stop mode while the FLASH is in read mode does not affect the operation of the
FLASH memory directly; however, no memory activity will take place since the CPU is inactive.
The STOP instruction should not be executed while performing a program or erase operation on the
FLASH. Stop mode will suspend any FLASH program/erase operations and leave the memory in a
standby mode.
NOTE
Standby mode is the power saving mode of the FLASH module, in which all
internal control signals to the FLASH are inactive and the current
consumption of the FLASH is minimum.
MC68HC908GR60A • MC68HC908GR48A • MC68HC908GR32A Data Sheet, Rev. 5
48
Freescale Semiconductor