MC908GR32AVFAE Datasheet, PDF (122/314 Pages) Freescale Semiconductor, Inc – Microcontrollers

Low-Power Modes
10.4 Central Processor Unit (CPU)
10.4.1 Wait Mode
The WAIT instruction:
• Clears the interrupt mask (I bit) in the condition code register, enabling interrupts. After exit from
wait mode by interrupt, the I bit remains clear. After exit by reset, the I bit is set.
• Disables the CPU clock
10.4.2 Stop Mode
The STOP instruction:
• Clears the interrupt mask (I bit) in the condition code register, enabling external interrupts. After
exit from stop mode by external interrupt, the I bit remains clear. After exit by reset, the I bit is set.
• Disables the CPU clock
After exiting stop mode, the CPU clock begins running after the oscillator stabilization delay.
10.5 Clock Generator Module (CGM)
10.5.1 Wait Mode
The clock generator module (CGM) remains active in wait mode. Before entering wait mode, software can
disengage and turn off the PLL by clearing the BCS and PLLON bits in the PLL control register (PCTL).
Less power-sensitive applications can disengage the PLL without turning it off. Applications that require
the PLL to wake the MCU from wait mode also can deselect the PLL output without turning off the PLL.
10.5.2 Stop Mode
If the OSCENINSTOP bit in the CONFIG2 register is cleared (default), then the STOP instruction disables
the CGM (oscillator and phase-locked loop) and holds low all CGM outputs (CGMXCLK, CGMOUT, and
CGMINT).
If the OSCENINSTOP bit in the CONFIG2 register is set, then the phase locked loop is shut off, but the
oscillator will continue to operate in stop mode.
10.6 Computer Operating Properly Module (COP)
10.6.1 Wait Mode
The COP remains active during wait mode. If COP is enabled, a reset will occur at COP timeout.
10.6.2 Stop Mode
Stop mode turns off the CGMXCLK input to the COP and clears the SIM counter. Service the COP
immediately before entering or after exiting stop mode to ensure a full COP timeout period after entering
or exiting stop mode.
The STOP bit in the CONFIG1 register enables the STOP instruction. To prevent inadvertently turning off
the COP with a STOP instruction, disable the STOP instruction by clearing the STOP bit.
MC68HC908GR60A • MC68HC908GR48A • MC68HC908GR32A Data Sheet, Rev. 5
122
Freescale Semiconductor