MC908GR32AVFAE Datasheet, PDF (258/314 Pages) Freescale Semiconductor, Inc – Microcontrollers

Timer Interface Module (TIM2)
CHxMAX — Channel x Maximum Duty Cycle Bit
When the TOVx bit is at a 1 and clear output on compare is selected, setting the CHxMAX bit forces
the duty cycle of buffered and unbuffered PWM signals to 100%. As Figure 18-9 shows, the CHxMAX
bit takes effect in the cycle after it is set or cleared. The output stays at 100% duty cycle level until the
cycle after CHxMAX is cleared.
NOTE
The 100% PWM duty cycle is defined as a continuous high level if the PWM
polarity is 1 and a continuous low level if the PWM polarity is 0. Conversely,
a 0% PWM duty cycle is defined as a continuous low level if the PWM
polarity is 1 and a continuous high level if the PWM polarity is 0.
OVERFLOW
OVERFLOW
PERIOD
OVERFLOW
OVERFLOW
OVERFLOW
PTDx/T2CHx
CHxMAX
OUTPUT
COMPARE
OUTPUT
COMPARE
OUTPUT
COMPARE
OUTPUT
COMPARE
Figure 18-9. CHxMAX Latency
18.8.5 TIM2 Channel Registers
These read/write registers contain the captured TIM2 counter value of the input capture function or the
output compare value of the output compare function. The state of the TIM2 channel registers after reset
is unknown.
In input capture mode (MSxB:MSxA = 0:0), reading the high byte of the TIM2 channel x registers
(T2CHxH) inhibits input captures until the low byte (T2CHxL) is read.
In output compare mode (MSxB:MSxA ≠ 0:0), writing to the high byte of the TIM2 channel x registers
(T2CHxH) inhibits output compares until the low byte (T2CHxL) is written.
Address: $0031 T2CH0H
Bit 7
6
5
4
3
2
1
Bit 0
Read:
Bit 15
Bit 14
Bit 13
Bit 12
Bit 11
Bit 10
Bit 9
Bit 8
Write:
Reset:
Indeterminate after reset
Address: $0032 T2CH0L
Bit 7
6
5
4
3
2
1
Bit 0
Read:
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
Write:
Reset:
Indeterminate after reset
Figure 18-10. TIM2 Channel Registers (T2CH0H/L:T2CH5H/L) (Sheet 1 of 3)
MC68HC908GR60A • MC68HC908GR48A • MC68HC908GR32A Data Sheet, Rev. 5
258
Freescale Semiconductor