MC908GR32AVFAE Datasheet, PDF (143/314 Pages) Freescale Semiconductor, Inc – Microcontrollers

Port D
T1CH1 and T1CH0 — Timer 1 Channel I/O Bits
The PTD7/T1CH1–PTD6/T1CH0 pins are the TIM1 input capture/output compare pins. The edge/level
select bits, ELSxB and ELSxA, determine whether the PTD7/T1CH1–PTD6/T1CH0 pins are timer
channel I/O pins or general-purpose I/O pins. See Chapter 17 Timer Interface Module (TIM1) and
Chapter 18 Timer Interface Module (TIM2).
SPSCK — SPI Serial Clock
The PTD3/SPSCK pin is the serial clock input of the SPI module. When the SPE bit is clear, the
PTD3/SPSCK pin is available for general-purpose I/O.
MOSI — Master Out/Slave In
The PTD2/MOSI pin is the master out/slave in terminal of the SPI module. When the SPE bit is clear,
the PTD2/MOSI pin is available for general-purpose I/O.
MISO — Master In/Slave Out
The PTD1/MISO pin is the master in/slave out terminal of the SPI module. When the SPI enable bit,
SPE, is clear, the SPI module is disabled, and the PTD1/MISO pin is available for general-purpose I/O.
SS — Slave Select
The PTD0/SS pin is the slave select input of the SPI module. When the SPE bit is clear, or when the
SPI master bit, SPMSTR, is set, the PTD0/SS pin is available for general-purpose I/O. When the SPI
is enabled, the DDRD0 bit in data direction register D (DDRD) has no effect on the PTD0/SS pin.
Data direction register D (DDRD) does not affect the data direction of port D pins that are being used by
the SPI module. However, the DDRD bits always determine whether reading port D returns the states of
the latches or the states of the pins. See Table 12-5.
12.6.2 Data Direction Register D
Data direction register D (DDRD) determines whether each port D pin is an input or an output. Writing a
1 to a DDRD bit enables the output buffer for the corresponding port D pin; a 0 disables the output buffer.
Address:
Read:
Write:
Reset:
$0007
Bit 7
6
5
4
3
2
1
DDRD7 DDRD6 DDRD5 DDRD4 DDRD3 DDRD2 DDRD1
0
0
0
0
0
0
0
Figure 12-14. Data Direction Register D (DDRD)
Bit 0
DDRD0
0
DDRD7–DDRD0 — Data Direction Register D Bits
These read/write bits control port D data direction. Reset clears DDRD7–DDRD0, configuring all port
D pins as inputs.
1 = Corresponding port D pin configured as output
0 = Corresponding port D pin configured as input
NOTE
Avoid glitches on port D pins by writing to the port D data register before
changing data direction register D bits from 0 to 1.
Figure 12-15 shows the port D I/O logic.
MC68HC908GR60A • MC68HC908GR48A • MC68HC908GR32A Data Sheet, Rev. 5
Freescale Semiconductor
143